Indian Pellet Industry Observes Limited Trades, Prices Likely To Be Affected
/https%3A%2F%2Fblog.ofbusiness.com%2Fwp-content%2Fuploads%2F2023%2F03%2F2-2.jpg)
The Indian pellet industry is currently facing a challenging time due to declining steel prices and limited trade. This situation has been primarily caused by the drop in mid-sized steel makers’ prices, which has led to low buying interest in the prevailing pellets prices. In this article, we will highlight the current situation, its impact on the industry, and its prospects.
Current Situation: Prices And Trade
Fe 63% pellets are currently being offered at around Rs 9,800-10,000/ton ex-Raipur and about Rs 10,000/ton ex-works in Durgapur, with only a few deals being reported. The situation does not look promising as trade experts predict further price cuts in the future if the current scenario remains unchanged.
Sponge iron prices have also dropped by Rs 1,000-1,500/ton in a week, particularly in the central and eastern regions. This drop had a ripple effect when it comes to the Indian pellet industry, resulting in declined demand and trade uncertainty among producers.
Impact On Indian Pellet Industry
Mid-sized steel makers’ declining prices have put further pressure on the Indian pellet industry, resulting in low buying interest on prevailing prices. Pellet producers in central and eastern regions have kept their prices stable against the previous week. However, buying interest continued lower, which seems to further put pressure on prices if buying remains poor for the sponge iron and billet in the domestic market, including finished steel products.
Insight
Buyers have been hesitant to place fresh raw materials orders for pellets and iron ore due to poor demand for sponge iron and the possibility of further price cuts. The recent Odisha Mining Corporation’s iron ore auction held for about 1 million tons also received a moderate response as the auction bids were near base prices, which has put buyers in cautious mode. Ultimately, it resulted in postponing spot demand for pellets by most steel mills in domestic markets, along with falling sponge iron and billet offers.
Read more: Steel Demand Lowers Continuously: Indian Ferrous Scrap Market Remains Sluggish
Suggested Readings
/https%3A%2F%2Fblog.ofbusiness.com%2Fwp-content%2Fuploads%2F2026%2F07%2FTemplate-OFb-32.png)
MS Channel Weight: ISMC Size Chart, Uses & Buying Guide
TL;DR: MS channels come in standard ISMC sizes, each with a fixed weight per meter that sets strength and cost. Picking the heaviest option isn’t always the right call; the correct size depends on load, span, and end use. This guide helps procurement managers choose the right channel and source it from verified suppliers on
/https%3A%2F%2Fblog.ofbusiness.com%2Fwp-content%2Fuploads%2F2026%2F07%2FTemplate-OFb-33.png)
MS Angle vs Channel: Steel Section Comparison
TL;DR: MS angle and MS channel are both hot-rolled structural steel sections, but they are not interchangeable. Angles suit bracing and lightweight framing, while channels carry higher loads across a span. This guide compares their standards, weight, cost, and buying process so fabricators and contractors pick the right section on OFB. MS angle and MS
/https%3A%2F%2Fblog.ofbusiness.com%2Fwp-content%2Fuploads%2F2026%2F06%2Funnamed.png)
TMT Bar Grades Explained: Fe415, Fe500, Fe500D, Fe550, Fe550D, and Fe600
TL;DR: TMT bar grades under IS 1786 run from Fe415 to Fe600, each defined by minimum yield strength and ductility. Grade selection depends on structural load, seismic zone, and project type. This guide helps construction buyers and procurement teams compare all six grades and source verified TMT bars through OFB. Indian construction projects specify TMT
